Description
The AquaChek TruTest strips fit into the TruTest AquaChek device for a digital reading of 3 parameters of your pool water: pH, free chlorine and alkalinity. It is very important to clean the lens of the device in time with a cotton swab.
AquaChek test strips for TruTest digital water tester – 50 pieces
Would you like to quickly and easily check the water values of your pool or spa? These test strips are specially developed for use with digital testers such as the AquaChek TruTest. They measure important parameters such as alkalinity, chlorine and pH. One test strip is suitable for a single measurement and provides accurate results within seconds.
Instructions for use
- Switch on your AquaChek TruTest digital tester with the on button.
- Dip a test strip into the pool water.
- Move the test strip briefly up and down in the water and take it out immediately.
- Shake off excess water from the strip.
- Place the test strip with the measuring pads facing down in the test device.
- Place the sun cover over the strip so that it is protected from direct light.
- Press 'Play' and read the measurement results. The tester indicates whether the values are too high (high), too low (low) or good (OK).
- Switch off the tester after use.
Storage advice
For a reliable measurement, the test strips must be stored correctly. Keep them at room temperature, in a dry place and out of the light. This keeps the strips in top condition so you can accurately test the water of your pool or spa time after time.
