Description
Gasket and air valve set for Intex sand filter pump
A sand filter pump that runs smoothly again, without water seeping along the connections or air being drawn into the system: that is exactly what you get back with this gasket and air valve set. After fitting, your filter is watertight and under pressure again, and it pumps your pool water round calmly and clearly, as if the pump were brand new.
The rubbers and the valve in a sand filter pump take a heavy beating year after year. Chlorine, sunlight and temperature fluctuations make the rubber hard and brittle over time. With this set you solve that in no time, so that your pump does its job fully again.
What you'll notice after replacing
No more dripping connections around the pump, no air bubbles bubbling through your system and a filter that returns to the correct pressure. The air valve also makes it easy to release air on start-up, so the pump draws in properly straight away and keeps filtering efficiently. The result is clearer water and a pump that runs quieter and more smoothly.
Fits your Intex pump
This set is made for the Intex sand filter pumps with a capacity of 6, 8 and 10 m³ per hour. Not sure whether your model is included? Check the flow rate on your pump's rating plate; if it falls within this range, you're good to go.
Small part, big difference
Worn seals and a leaking valve are often the cause of a pump that performs less well or keeps drawing in air. By replacing these parts in time, you prevent bigger problems and extend the lifespan of your sand filter pump. This keeps your pool crystal clear all season long, without any hassle.
