Dolphin Zenit 30 pool robot with foam brushes for smooth surfaces

A transport cart for placing the robot and rolling up the cable is included as standard. The Zenit 30 pool robot has an 18-meter cable length and is suitable for pools up to 15 meters in length. The unit does both bottom and walls. The swivel ensures that the cable does not torque through use. The included remote control allows manual control or adjustment of the robot.

Cleaning the pool

The Maytronics range pool robot the Zenit 30 provides excellent cleaning of your pool floor and walls. The robot has a robust pump of 17m³/h built in to maximize suction and store the contamination in the filter cartouches. These cartouches should be cleaned by hand. A coarse and fine filter are supplied as standard and can be replaced at any time. The standard cycle is set to 3 hours, after which the robot simply shuts down. It should therefore be removed from the water to extend its life. When there is a lot of dirt in the water the robot will stop when there is too much dirt in the filter cartridge as a safety precaution against burning the motor.

What's in the basic package

• Robot with PVC brushes
• Active center brush for scrubbing loose dirt
• 18 m floating cable with swivel
• Transport cart
• Fine and coarse filters
• Multifunctional electrical transformer
• Remote control

Maytronics Swivel system

The Zenit 30 pool robot is equipped with a swivel on the floating cable, this ensures that the cable does not torque when using the robot. This innovative component ensures easy maintenance of your cable, long life guaranteed!

Filter cartridges

The Zenit range is equipped with removable filter cartouches. The cartouches are available in 2 different thicknesses. The coarse cartouches are mainly used in the spring for the removal of leaves and other coarser material, the fine filters are used all year round and have an equally fine filtration as the sand filters. The cartouches are easy to remove and can be rinsed off with a garden hose. Always available separately.

Active center brush

Maytronics active center brush has a scrubbing function to remove biofilm in your pool. Removing the biofilm already reduces the chances of algae blooms! The middle brush rotates twice as fast in the opposite direction creating a cyclone effect under the robot and the dirt is sucked in even better. This brush can always be replaced after X number of years of use. Easy to disassemble with 4 screws.

Adjustable handle

The Zenit 30 pool robot is equipped with a movable handle. This handle has 2 functions; the first function is to hold the device in order to place it in and out of the water. The second function is for optimal cleaning of your pool. This handle must always be at right angles. The direction of the robot is thus determined. Depending on the position of the handle, the device will always turn clockwise or counterclockwise.

Remote control

The Zenit 30 is equipped with a remote control, with this it is possible to make some adjustments to the operation of the device. It is possible through the remote control to manually drive around the robot, this way you can still quickly clean the pool. It is also possible to adjust the settings of the cleaning behavior: bottom only, bottom and walls, bottom at a slow speed, clean more water line (three meters instead of one meter).

Combined brushes

The combined brushes are designed to drive up the walls in both liner pools and some polyester pools. For mosaic pool it is recommended to use the mousse brushes.

Compare with other pool robots in the series